Tools needed:
1/4" drive 10mm socket with knuckle and extension.
Error creating thumbnail: Unable to save thumbnail to destination
Time taken:
20mins (including photos) but I have done it a few times now.
Error creating thumbnail: Unable to save thumbnail to destination
Remove clips for plastic panel (5 in total).
Error creating thumbnail: Unable to save thumbnail to destination
3 bolts are used to hold the headlight into the car.
Slacken off the 2 that are visible in the engine bay.
Error creating thumbnail: Unable to save thumbnail to destination
Pull the wheel arch lining out a little from behind the bumper, to expose a screw holding the bumper to the wing.
Remove screw.
Error creating thumbnail: Unable to save thumbnail to destination
Pull the bumper away from the wing and you can see the 3rd bolt for the headlight.
Error creating thumbnail: Unable to save thumbnail to destination
Undo bolt (using the knuckle makes it a lot easier).
Error creating thumbnail: Unable to save thumbnail to destination
Now remove the other 2 bolts completely in the engine bay.
Unclip the washer bottle from the headlight casing (offside headlight only).
Error creating thumbnail: Unable to save thumbnail to destination
Partially remove the headlight (it won't go far as the bulbs and height adjuster are still connected).
Error creating thumbnail: Unable to save thumbnail to destination
Remove the bulb connectors by pressing down on the tabs arrowed.
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
(This is different as I have HID's)
Error creating thumbnail: Unable to save thumbnail to destination
Now you can remove you headlight completely.
Error creating thumbnail: Unable to save thumbnail to destination
And change the bulbs with ease
Error creating thumbnail: Unable to save thumbnail to destination
