Gen6 oil change
From Wiki
Engine Oil/Filter Replacement:
- Run engine until warm (50 C)
- Remove sump bung and leave to drain for 30 mins
- Punch hole in bottom of Filter, using a screwdriver or punch, to drain oil
- Remove oil filter (Lower O/S/F of engine)
- Fit new oil filter
- Replace sump bung and tighten to 25 Nm (18.4 Lb-Ft)
- Remove oil filler cap (O/S/R of rocker cover)
- Fill with 4 litres of engine oil & replace oil filler cap
- Run engine
- Turn off (wait for 5 mins for oil to settle)
- Check level and top up until oil is at max mark on dipstick
