Difference between revisions of "Gen6 spark plugs"

Revision as of 20:35, 27 January 2008

Spark Plug Replacement:

• Remove HT leads from sparkplugs located on the rear side of the engine noting cylinder assignment.
• Remove plugs from cylinder head
• Check gap of new plugs using feeler gauge (NGK Spec: 0.8mm although this should be preset)
• If adjustment is required use a soft faced mallet to adjust. Don’t ever leave feeler gauge in whilst adjusting gap.
• Smear a small amount of copper grease or molybdenum grease around the threads, avoiding leading 3 threads.
• Fit plugs into cylinder head and torque to 18Nm (13.3 lb-ft)
• Refit HT Leads

Recommended NGK plugs for 3S-GE = BKR6EP-82215 Toyota P/N = 90919-01180

Gap is preset

HT Lead Resistance: <25K Ohm PER Lead

Back to Gen 6 Routine Servicing

Back to Gen 6 Maintenance menu