Difference between revisions of "Engine Diagnostic Codes"
From Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 8: | Line 8: | ||
[[Image:3SGTE Fault Codes 2.jpg]] | [[Image:3SGTE Fault Codes 2.jpg]] | ||
| + | --[[User:Rpsmith79|Rich]] 21:31, 26 December 2010 (UTC) | ||
| − | |||
---- | ---- | ||
| − | [[Generation 5|Back To Gen 5 Maintenance]] | + | [[Generation 5|Back To Gen 5 Maintenance]]<br> |
| + | [[Generation Five|Back To Gen 5 Modification]] | ||
Latest revision as of 07:13, 15 June 2011
To check the engine diagnostic codes, bridge terminals TE1 & E1 with a piece of wire (or a paperclip) in the Diagnostics box located on the right hand side of the engine bay near the bulkhead.
Then turn the ignition 2 clicks until the engine light illuminates, count the flashes, each code is 2 digits long so you will get a series of flashes, then a pause, then a series of flashes, this will indicate the 1st & 2nd digit of the code. If there are multiple codes there will be a long pause then the next code will be displayed.
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
--Rich 21:31, 26 December 2010 (UTC)
