Difference between revisions of "Engine Diagnostic Codes"
From Wiki
| Line 2: | Line 2: | ||
Then turn the ignition 2 clicks until the engine light illuminates, count the flashes, each code is 2 digits long so you will get a series of flashes, then a pause, then a series of flashes, this will indicate the 1st & 2nd digit of the code. If there are multiple codes there will be a long pause then the next code will be displayed. | Then turn the ignition 2 clicks until the engine light illuminates, count the flashes, each code is 2 digits long so you will get a series of flashes, then a pause, then a series of flashes, this will indicate the 1st & 2nd digit of the code. If there are multiple codes there will be a long pause then the next code will be displayed. | ||
| + | |||
[[Image:3SGTE Fault Codes 1.jpg]] | [[Image:3SGTE Fault Codes 1.jpg]] | ||
[[Image:3SGTE Fault Codes 2.jpg]] | [[Image:3SGTE Fault Codes 2.jpg]] | ||
| + | |||
| + | ---- | ||
| + | |||
| + | [[Generation_Five|Back To Gen 5 Modifications]] | ||
Revision as of 10:41, 23 December 2010
To check the engine diagnostic codes, bridge terminals TE1 & E1 with a piece of wire (or a paperclip) in the Diagnostics box located on the right hand side of the engine bay near the bulkhead.
Then turn the ignition 2 clicks until the engine light illuminates, count the flashes, each code is 2 digits long so you will get a series of flashes, then a pause, then a series of flashes, this will indicate the 1st & 2nd digit of the code. If there are multiple codes there will be a long pause then the next code will be displayed.
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
