View source for Ebay Induction Kit Guide


== [['''Ebay Induction Kit Installion Guide''']] ==

Here's my first guide, hope this helps people out with the Ebay Induction Kit. It should apply for any other similar short ram style induction kits.



1. Unclip top of airbox (3 clips around the sides) 
2. Undo pipe on throttle body and remove
3. Remove top part of airbox.
4. Locate and remove two 10mm bolts holding bottom of airbox on and remove bottom airbox part
5. Meanwhile disconnect the pipe with the blue valve on the end from the airbox and the blue electrical connector

Induction On:

6. Use the smallest blue piping on the induction pipe, put two bracket rings over the pipe and drop over the pipe, dont tighten.
7. Place pipe and tubing over the throttle body (remove ecu cooling pipe if you find it easier)
8. Use brackets and tighten (dont overly tighten the induction pipe side one, we need to adjust the posistion later.
9. Put MAF on and screw on, attach connector.
10. Secure cone with bracket onto the pipe.

11. If you want to use the support bracket use the airbox bolt on the bodywork. (I coudnt get this off so i used the fusebox support bolt). Dont be afraid to bend the bracket. Buy a bolt (10mm I think) and nylon nut and secure.

I managed to get the engine plastics on the front back on, but personal preference because they do come very close (yours might not if you use the airbox bolt for the support.

Block off the loose pipe (blue valve one) and cut a bit of the pipe off the other end, use it on the extra small exit on the pipe after the filter, and block off (dont use the thick blue ebay piping). Tie back the blue electrical plug.


Any questions feel free to PM me! 

Ben (CelicaBen140)