View source for Gen6 spark plugs

Spark Plug Replacement:

* Remove HT leads from sparkplugs located on the rear side of the engine noting cylinder assignment.
* Remove plugs from cylinder head
* Check gap of new plugs using feeler gauge (NGK Spec: 0.8mm although this should be preset)
* If adjustment is required use a soft faced mallet to adjust. Don’t ever leave feeler gauge in whilst adjusting gap.
* Smear a small amount of copper grease or molybdenum grease around the threads, avoiding leading 3 threads.
* Fit plugs into cylinder head and torque to 18Nm (13.3 lb-ft)
* Refit HT Leads

Recommended NGK plugs for 3S-GE = '''BKR6EP'''-82215
Toyota P/N = 90919-01180

Gap is preset

HT Lead Resistance: <25K Ohm PER Lead





----

[[gen6 servicing|Back to Gen 6 Routine Servicing]]

[[Generation_6|Back to Gen 6 Maintenance menu]]